[link]
This reinforcement learning paper starts with the constraints imposed an engineering problem  the need to scale up learning problems to operate across many GPUs  and ended up, as a result, needing to solve an algorithmic problem along with it. In order to massively scale up their training to be able to train multiple problem domains in a single model, the authors of this paper implemented a system whereby many “worker” nodes execute trajectories (series of actions, states, and reward) and then send those trajectories back to a “learner” node, that calculates gradients and updates a central policy model. However, because these updates are queued up to be incorporated into the central learner, it can frequently happen that the policy that was used to collect the trajectories is a few steps behind from the policy on the central learner to which its gradients will be applied (since other workers have updated the learner since this worker last got a policy download). This results in a need to modify the policy network model design accordingly. IMPALA (Importance Weighted Actor Learner Architectures) uses an “Actor Critic” model design, which means you learn both a policy function and a value function. The policy function’s job is to choose which actions to take at a given state, by making some higher probability than others. The value function’s job is to estimate the reward from a given state onward, if a certain policy p is followed. The value function is used to calculate the “advantage” of each action at a given state, by taking the reward you receive through action a (and reward you expect in the future), and subtracting out the value function for that state, which represents the average future reward you’d get if you just sampled randomly from the policy from that point onward. The policy network is then updated to prioritize actions which are higheradvantage. If you’re onpolicy, you can calculate a value function without needing to explicitly calculate the probabilities of each action, because, by definition, if you take actions according to your policy probabilities, then you’re sampling each action with a weight proportional to its probability. However, if your actions are calculated offpolicy, you need correct for this, typically by calculating an “importance sampling” ratio, that multiplies all actions by a probability under the desired policy divided by the probability under the policy used for sampling. This cancels out the implicit probability under the sampling policy, and leaves you with your actions scaled in proportion to their probability under the policy you’re actually updating. IMPALA shares the basic structure of this solution, but with a few additional parameters to dynamically trade off between the bias and variance of the model. The first parameter, rho, controls how much bias you allow into your model, where bias here comes from your model not being fully corrected to “pretend” that you were sampling from the policy to which gradients are being applied. The tradeoff here is that if your policies are far apart, you might downweight its actions so aggressively that you don’t get a strong enough signal to learn quickly. However, the policy you learn might be statistically biased. Rho does this by weighting each value function update by: https://i.imgur.com/4jKVhCe.png where rhobar is a hyperparameter. If rhobar is high, then we allow stronger weighting effects, whereas if it’s low, we put a cap on those weights. The other parameter is c, and instead of weighting each value function update based on policy drift at that state, it weights each timestep based on how likely or unlikely the action taken at that timestep was under the true policy. https://i.imgur.com/8wCcAoE.png Timesteps that much likelier under the true policy are upweighted, and, once again, we use a hyperparameter, cbar, to put a cap on the amount of allowed upweighting. Where the prior parameter controlled how much bias there was in the policy we learn, this parameter helps control the variance  the higher cbar, the higher the amount of variance there will be in the updates used to train the model, and the longer it’ll take to converge.
Your comment:
